Durango 2WD V8-5.7L (2008)
Air Door Actuator / Motor: Service and Repair
Blend Door Actuator - Installation
Front Controls
INSTALLATION
NOTE: The single zone heating-A/C system is equipped with a single blend door actuator. The dual zone system has two blend door actuators,
one for the driver side blend-air door and one for the passenger side blend-air door.
SINGLE ZONE/DUAL ZONE DRIVER SIDE
1. Position the blend door actuator (1) to the top of the HVAC housing (2). If necessary, rotate the actuator slightly to align the splines on the
actuator output shaft (3) with those on the blend-air door linkage (4).
2. Install the three screws (4) that secure the blend door actuator (2) to the top of the HVAC housing (3). Tighten the screws to 2 Nm (17 in. lbs.).
3. Connect the HVAC wire harness connector (1) to the blend door actuator.
4. Install the instrument panel assembly See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and Repair/Instrument
Panel - Installation.
5. Reconnect the negative battery cable.
6. Initiate the Actuator Calibration function using a scan tool See: Testing and Inspection/Component Tests and General Diagnostics/HVAC System
Test or See: Testing and Inspection/Component Tests and General Diagnostics/HVAC System Test.
DUAL ZONE PASSENGER SIDE
