Durango 2WD V8-5.7L (2008)
8. Install the air inlet housing (5) onto the top of the HVAC housing (1).
9. Install the screws (4) that secure the air inlet housing to the HVAC housing. Make sure the HVAC wire harness retainer is properly installed.
10. Connect the HVAC wire harness (2) to the recirculation door actuator (3).
11. Install the front HVAC housing .
12. Reconnect the negative battery cable.
13. If the heater core is being replaced, flush the cooling system See: Engine, Cooling and Exhaust/Cooling System/Service and Repair.
14. Refill the engine cooling system See: Engine, Cooling and Exhaust/Cooling System/Service and Repair.
15. Evacuate the refrigerant system See: Service and Repair/Refrigerant System Evacuate.
16. Charge the refrigerant system See: Service and Repair/Refrigerant System Charge.
