Durango 2WD V8-5.7L (2008)
Control Module: Service and Repair
TCM Quick Learn
TCM QUICK LEARN
The quick learn procedure requires the use of a scan tool.
This program allows the electronic transmission system to re-calibrate itself. This will provide the proper transmission operation. The quick learn
procedure should be performed if any of the following procedures are performed:
-
Transmission Assembly Replacement
-
Transmission Control Module Replacement
-
Solenoid Pack Replacement
-
Clutch Plate and/or Seal Replacement
-
Valve Body Replacement or Recondition
To perform the Quick Learn Procedure, the following conditions must be met:
-
The brakes must be applied
-
The engine speed must be above 500 rpm
-
The throttle angle (TPS) must be less than 3 degrees
-
The shift lever position must stay in PARK until prompted to shift to overdrive
-
The shift lever position must stay in overdrive after the Shift to Overdrive prompt until the scan tool indicates the procedure is complete
-
The calculated oil temperature must be above 15° C (60° F) and below 93° C (200° F)
