Durango 2WD V8-5.7L (2008)
Mopar(R) Parts Catalog.
1. Check to be certain that the molded plastic retractor cup (2) is properly installed in the retractor mounting hole (1) of the inner D-pillar, and that it
is in good condition.
2. Position the third row outboard seat belt and retractor (5) to the D-pillar as a unit.
3. Install and tighten the screw (6) that secures the retractor bracket to the lower D-pillar. Tighten the screw to 39 Nm (29 ft. lbs.).
4. Position the seat belt turning loop (3) to the inside of the upper D-pillar.
5. Install and tighten the screw (4) that secures the turning loop to the D-pillar. Tighten the screw to 39 Nm (29 ft. lbs.).
6. Reinstall the quarter trim panel to the lower D-pillar. See: Body and Frame/Interior Moulding / Trim/Trim Panel/Service and Repair/Quarter Panel
Trim/Quarter Trim Panel - Installation.
7. Route the seat belt (2) and lower anchor through the access hole in the D-pillar trim panel (1).
8. Reinstall the D-pillar trim panel to the inside of the upper D-pillar. See: Body and Frame/Interior Moulding / Trim/Trim Panel/Service and
Repair/Pillar Trim/D-Pillar Trim/Installation.
