Durango 2WD V8-5.7L (2008)
4. Adjust the lower spacers (3) as required, to obtain the specified roof gap tolerance by pushing on the side of the wedge and raising or lowering the
glass as necessary. For roof gap specifications, refer to the table Roof Gap Tolerances.
5. Clean and check windshield for damage.
6. Position windshield in center of windshield opening.
7. Apply adhesive tape to the locations shown to aid with final installation.
8. Verify windshield gap is parallel to with windshield.
9. Cut tape with a sharp knife and remove windshield.
10. Clean and dry area of glass to be glued with a suitable glass preparation solvent and rag.
11. Apply primer to gluing surface at windshield seal.
12. Apply primer (1) around the perimeter of the glass to a width of 15 mm (0.5 in.) (2).
