Durango 2WD V8-5.7L Hybrid (2009)
The camera image sensor and electronics are sealed and protected within a two-piece die cast zinc housing (1), held together by four screws (2). The
camera lens (5) extends from the lower surface of the housing and an integral connector receptacle (3) containing five terminal pins that extends from the
right side of the housing. Additionally, there are three mounting bosses (4) integral to the camera housing, two on the left side and one on the right. The
mounting bosses receive the three self-tapping screws securing the unit to the camera bracket.
Hardwired circuitry connects the RVC to the electrical system of the vehicle. These hardwired circuits are integral to several wire harnesses, which
routes throughout the vehicle and retained by many different methods. These circuits may be connected to each other and to the vehicle electrical system
through the use of a combination of soldered splices, splice block connectors, and many different types of wire harness terminal connectors and
insulators. Refer to the appropriate wiring information. The wiring information includes wiring diagrams, proper wire and connector repair procedures,
further details on wire harness routing and retention, as well as pin-out and location views for the various wire harness connectors, splices and grounds.
The RVC cannot be adjusted or repaired. If the RVC is damaged or ineffective, it must be replaced.
