Durango 2WD V8-5.7L Hybrid (2009)
Parking Assist Control Module: Service and Repair
Park Assist Module - Removal
REMOVAL
1. Disconnect and isolate the battery negative cable. On vehicles equipped with the optional Hybrid Electric Vehicle (HEV) system, a technician
trained in proper HEV service safety procedures must also remove the high voltage service disconnect from the high voltage battery pack.
2. Remove the trim from the left quarter inner panel to access the park assist module (5), which is located behind the power liftgate module (3) to the
rear of the C-pillar (2) and above the left rear wheel housing. See: Body and Frame/Interior Moulding / Trim/Trim Panel/Service and
Repair/Luggage Compartment Trim/Quarter Trim Panel - Removal.
3. Disconnect the two body wire harness connectors (1) from the park assist module connector receptacles.
4. Remove the three plastic push-in fasteners (4) that secure the module to the left quarter inner panel.
5. Remove the module from the left quarter inner panel.
