Durango 2WD V8-5.7L Hybrid (2009)
Trunk / Liftgate Handle: Service and Repair
Exterior Handle - Installation
INSTALLATION
1. Install the lamp socket into the lamp housing in the handle and turn it a half turn.
2. Install the handle to the liftgate and snap home the four clips 2 and 4 beginning with the middle two then the outer two.
3. Install the screws (3).
4. Insert the bent end of the latch actuator rod (2) to the swing clip on the latch (4), and snap clip onto rod. Then without changing the position of the
liftgate outside handle (1), snap the grooved end of the rod into the metal clip on the handle.
5. Install the trim panels, See: Trunk / Liftgate Interior Trim Panel/Service and Repair/Liftgate Trim Panel - Installation.
