Durango 2WD V8-5.7L Hybrid (2009)
3. Position the seat belt turning loop (4) to the height adjuster (1).
4. Install the screw (3) and tighten the to 39 Nm (29 ft. lbs.).
5. Engage the tab (2) on the lower edge of the trim cover (3) in the slot below the screw in the turning loop (1). Then press the upper edge of the trim
cover over the top of the turning loop until it snaps into place.
Removal
REMOVAL
1. Remove the third row seat as necessary to access to the seat belt lower anchor (2) on the quarter inner panel (3). See: Seats/Service and
