Durango 2WD V8-5.7L Hybrid (2009)
Hood Sensor/Switch (For Alarm): Service and Repair
Vehicle Theft Security Hood Ajar Switch - Installation
Striker
STRIKER
NOTE: Vehicles equipped with two hood ajar switches are also equipped with two strikers.
NOTE: The hood ajar switch striker caps are not intended for reuse. If the striker cap is removed from the hood inner reinforcement for any
reason, it must be replaced.
1. Position the new hood ajar switch striker (2) into the large end of the keyed mounting hole (3) in the inner hood panel reinforcement (1) over the
hood ajar switch.
2. Using hand pressure, slide the striker upward into the small end of the mounting hole in the inner hood panel reinforcement until it is fully
engaged.
3. Close and latch the hood.
Switch
SWITCH
NOTE: Some vehicles are equipped with two hood ajar switches.
1. Position the hood ajar switch (1) near the mounting hole (2) in the left front fender inner shield.
2. Reconnect the wire harness connector (3) to the switch connector receptacle.
3. Insert the switch into the mounting hole until the integral switch latch tabs lock it into place.