Durango 2WD V8-5.7L Hybrid (2009)
Hydraulic Control Assembly - Antilock Brakes: Service and Repair
Hydraulic Control unit (HCU) - Installation
INSTALLATION
1. Reinstall the HCU assembly through the left wheel well.
2. Install HCU assembly on the mounting bracket and Tighten the nuts to 15 Nm (11 ft. lbs.).
3. Install the brake lines (1) to the HCU (4) and tighten to 19 Nm (170 in. lbs.).
4. Install the electrical harness connector (3) to the HCU/ABM assembly (4).
5. Install the chassis lines (1) to the HCU/ABM (2) and tighten to 19 Nm (170 in. lbs.).
6. Install the left front tire.
7. Install negative battery cable to the battery.
8. Remove the brake pedal prop rod.
9. Bleed ABS brake system See: Brake Bleeding/Service and Repair.
10. Connect the scan tool and initialize the ABM by performing the ABS Verification Test See: Powertrain Management/Computers and Control
Systems/Testing and Inspection/Diagnostic Trouble Code Tests and Associated Procedures/Verification Tests/ABS Verification Test.
