Durango 2WD V8-5.7L Hybrid (2009)
9. Connect the steering column harness to the retainer (1), the four brake pedal assembly component connectors (2-5), and the brake pedal angle
sensor connector (not shown) located at the top left outside area of the brake pedal assembly.
10. Install the main I/P harness connector (1) bracket bolts (2) to the brake pedal assembly. Tighten the bolts to 28 Nm (250 in. lbs.).
CAUTION: Do not reuse the original stop lamp switch. Anytime a switch has been removed or its position compromised, a new switch must be
installed and adjusted. Do not attempt to readjust the switch.
11. Install and adjust a NEW stop lamp switch. See: Lighting and Horns/Brake Light Switch/Service and Repair/Stop Lamp Switch - Installation
12. Install the steering column, See: Steering and Suspension/Steering/Steering Column/Service and Repair/Steering Column - Installation
