Durango 2WD V8-5.7L Hybrid (2009)
Vacuum Pump: Service and Repair
Installation
INSTALLATION
1. Install the vacuum pump (3).
-
Place a lower bolt (5) through the electrical harness/air conditioning tube retainer bracket (4) for installation in the bottom bolt position on the
electric vacuum pump bracket (1) and install the lower bolts (5) but do not tighten.
-
Install the upper bolt and nut (2). Tighten the upper bolt and nut to 40 Nm (29.5 ft. lbs.).
-
Tighten the lower bolts (5) to 20 Nm (15 ft. lbs.).
2. Position the battery cable junction block with the tab in the alignment hole and install the battery cable junction block retainer bolt (4) finger tight
only.
NOTE: For proper connections, ensure that the two battery cables (3) are positioned as observed during removal and DO NOT stack the
crimp of the top terminal directly above the crimp of the bottom terminal.
3. Position the positive battery cables (3) over the studs and install the positive battery cable nuts (2). Tighten the nuts to 10 Nm (90 in. lbs.).
4. Secure the positive battery cable access cover (1).
