Durango 2WD V8-5.7L Hybrid (2009)
1. If removed, install the TPIM coolant temperature sensor. Tighten to 20 Nm (177 in. lbs.)
2. Position the Transmission/TPIM cooler.
3. Install the upper mounting bolts.
4. Install the lower mounting bolts
5. Tighten bolts to 8.5 Nm (75 in. lbs.).
6. Clip the transmission tubes (3) into the retainers (2) on bottom of the radiator.
7. Install the transmission cooler lines (4) onto the cooler tubes (3).
8. Install the coolant hose.
9. Connect the temperature sensor electrical connector.
10. Install the coolant pump See: Water Pump/Service and Repair/Removal and Replacement/TPIM Coolant Pump - Installation
11. Fill the cooling system See: Service and Repair/Cooling System Filling
12. Connect negative battery cable.
13. Perform HEV specific high voltage power up and high voltage isolation check safety procedures. See: Hybrid Drive Systems/Battery System,
Hybrid Drive/Service and Repair/Battery System - High Voltage Power Up
