Durango 2WD V8-5.7L Hybrid (2009)
Camshaft: Removal and Replacement
Camshaft - Removal
CAMSHAFT
WARNING: On vehicles equipped with the high voltage system, you must thoroughly read and follow all High Voltage Safety procedures. In
addition, before performing any diagnostic or service procedure near a high voltage component, you must perform the High
Voltage Power Down. Failure to follow these instructions may result in possible serious or fatal injury See: Hybrid Drive
Systems/Battery System, Hybrid Drive/Service Precautions
1. Perform the fuel system pressure release procedure See: Cylinder Head Assembly/Fuel Pressure Release/Service and Repair
2. Perform the HEV high voltage power down procedure See: Hybrid Drive Systems/Battery System, Hybrid Drive/Service and Repair/Battery
System - High Voltage Power Down
3. Disconnect the 12 volt battery system ground isolation connector (1) and remove the connector from the electric vacuum pump bracket (2).
4. Disconnect the high voltage inter lock (HVIL) electrical connector (1).
5. Remove the clean air tube retaining bolt (3).
6. Remove the clean air tube (2).
