Durango 2WD V8-5.7L Hybrid (2009)
CAUTION: The rocker shaft assemblies are not interchangeable between the intake and the exhaust, failure to install them in the correct
location could result in engine damage. The intake rocker arms (1) are marked with the letter "I" (2).
3. Install the rocker shaft assemblies in the same order as removed.
4. Using the sequence shown, tighten the rocker shaft bolts to 22 Nm (16 ft. lbs.).
CAUTION: Do Not rotate or crank the engine during or immediately after rocker arm installation. Allow the hydraulic roller tappets
adequate time to bleed down (about five minutes).
5. Remove the pushrod retainer (1) 9070.