Durango 2WD V8-5.7L Hybrid (2009)
11. Wipe the connecting rod cap (1) clean and lubricate with clean engine oil and install the bearing (3).
12. Remove special tool 8507 connecting rod guides.
NOTE: The connecting rods and bearing caps are not interchangeable, line up the previously marked bearing caps and connecting rods to
ensure assembly to their original location.
13. Lubricate the bearing surfaces with clean engine oil and position the rod cap in place.
14. Lubricate the new rod bolts with clean engine oil.
15. Install the new and lubricated rod bolts and tighten to 21 Nm (15 ft. lbs.) plus a 90° turn.
16. Install the cylinder head(s) See: Cylinder Head Assembly/Service and Repair/Removal and Replacement/Cylinder Head - Installation
17. Install the timing chain cover See: Timing Components/Timing Cover/Service and Repair/Engine Timing Cover(s) - Installation
18. Install the cylinder head covers See: Cylinder Head Assembly/Valve Cover/Service and Repair/Cylinder Head Cover(s) - Installation
19. Install the intake manifold See: Intake Manifold/Service and Repair/Removal and Replacement/Intake Manifold - Installation
20. Install the new oil pan gasket/windage tray and oil pan See: Engine Lubrication/Oil Pan/Service and Repair/Engine Oil Pan - Installation
21. Fill the engine with oil See: Engine Lubrication/Engine Oil/Service and Repair