Durango 2WD V8-5.7L Hybrid (2009)
Oil Pressure Sensor: Service and Repair
Oil Pressure Sensor - Removal
REMOVAL
WARNING: On vehicles equipped with the high voltage system, you must thoroughly read and follow all High Voltage Safety procedures. In
addition, before performing any diagnostic or service procedure near a high voltage component, you must perform the High
Voltage Power Down. Failure to follow these instructions may result in possible serious or fatal injury See: Hybrid Drive
Systems/Battery System, Hybrid Drive/Service Precautions
1. Perform the High Voltage Power Down Procedure . See: Hybrid Drive Systems/Battery System, Hybrid Drive/Service and Repair/Battery System
- High Voltage Power Down
2. Raise and support the vehicle.
3. Disconnect the oil pressure sensor electrical connector (1).
4. Remove the oil pressure sensor (1).
