Durango 2WD V8-5.7L Hybrid (2009)
Timing Cover: Service and Repair
Engine Timing Cover(s) - Installation
INSTALLATION
WARNING: On vehicles equipped with the high voltage system, you must thoroughly read and follow all High Voltage Safety procedures. In
addition, before performing any diagnostic or service procedure near a high voltage component, you must perform the High
Voltage Power Down. Failure to follow these instructions may result in possible serious or fatal injury See: Hybrid Drive
Systems/Battery System, Hybrid Drive/Service Precautions
1. Clean timing chain cover and block sealing surfaces.
NOTE: Always install a new gasket on timing cover.
2. Install cover and new gasket. Tighten fasteners to 28 Nm (250 in. lbs.) in the sequence shown.
3. The large lifting stud (1) is tightened to 55 Nm (40 ft. lbs.).
4. Install the oil pan and pick up tubeSee: Engine Lubrication/Oil Pan/Service and Repair/Engine Oil Pan - Installation.
5. Install the dipstick support bolt.
6. Install the thermostat housing.
7. Install crankshaft damperSee: Cylinder Block Assembly/Harmonic Balancer - Crankshaft Pulley/Service and Repair/Vibration Damper -
Installation.
