dodge Workshop Repair Guides

Dodge Workshop Service and Repair Manuals

Blend Door Actuator - Description|Page 6672 > < Blend Door Actuator - Description|Page 6670
Page 3
background image

The two mode door actuators (floor/defrost and panel door) (1) are reversible, 12-volt direct current (DC), servo motors. Both mode door actuators are
located near the drivers side end of the HVAC housing. The mode door actuators are mechanically connected to the floor/defrost and the panel-air door.
Both mode door actuators are  interchangeable with each other and with the actuators for the blend-air door and the recirculation-air door. Each actuator
is contained within an identical black molded plastic housing with an integral wire connector receptacle. Three integral mounting tabs allow the actuator
to be secured to the top of the HVAC housing. Each actuator also has an identical output shaft with splines that connects it to the mode-air doors. The
mode door actuators do not require mechanical indexing to the mode-air doors, as they are electronically calibrated by the A/C-heater control.

Rear

DESCRIPTION

The rear mode door actuator (1) is a reversible, 12 volt direct current (DC), servo motor. The rear mode door actuator is located on the inboard side of
the rear heater-A/C housing. The rear mode door actuator is contained within a black molded plastic housing which has an integral wire connector
receptacle (2), three integral mounting tabs (4) and an output shaft with splines (3) that connect the actuator to the rear mode-air door. The rear mode
door actuator is interchangeable with the actuator for the blend-air door.

The rear mode door actuator does require mechanical indexing to the rear mode-air door, as it is electronically calibrated by the A/C-heater control.

Front

OPERATION

The floor/defrost and panel (mode) door actuators are connected to the A/C-heater control through the vehicle electrical system by a dedicated two-wire
lead and connector of the HVAC wire harness. The mode door actuators can move the floor/defrost and the panel-air doors in two directions. When the
A/C-heater control pulls the voltage on one side of the motor connection high and the other connection low, the mode-air door(s) will move in one

Blend Door Actuator - Description|Page 6672 > < Blend Door Actuator - Description|Page 6670