dodge Workshop Repair Guides

Dodge Workshop Service and Repair Manuals

Blend Door Actuator - Removal|Page 6688 > < Blend Door Actuator - Removal|Page 6686
Page 5
background image

2. Install the two screws (4) that secure the rear blend door actuator (1) to the rear heater-A/C housing (3). Tighten the screws to 2 Nm (17 in. lbs.).
3. Connect the rear heater-A/C wire harness connector (2) to the rear blend door actuator.
4. Install the right rear quarter panel trim See: Body and Frame/Interior Moulding / Trim/Trim Panel/Service and Repair/Luggage Compartment

Trim/Quarter Trim Panel - Installation.

5. Reconnect the negative battery cable.
6. Initiate the Actuator Calibration function using a scan tool   See: Testing and Inspection/Component Tests and General Diagnostics/HVAC System

Test.

7. Verify that the Actuator Calibration of the front A/C-heater control has passed. If an Actuator Calibration has not passed, correct any errors before

proceeding.

8. Rotate the Rear Temperature Selector counter (1) clockwise to the Cold Position. Allow the Selector to remain in the Cold Position for 5 seconds.
9. Rotate the Rear Temperature Selector Clockwise to the Hot Position. Allow the Selector to remain in the Cold Position for 5 seconds.

10. Calibration is now complete.

Front

REMOVAL

WARNING: Disable the airbag system before attempting any steering wheel, steering column or instrument panel component diagnosis or

service. Disconnect and isolate the negative battery (ground) cable and wait two minutes for the airbag system capacitor to
discharge before performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to follow
these instructions may result in accidental airbag deployment and possible serious or fatal injury.

1. Disconnect and isolate the negative battery cable.
2. Remove the screws (5) that secure the panel door actuator (2) and the floor/defrost door actuator (3) located on the driver side end of the HVAC

housing (4) as required.

3. Disconnect the HVAC wire harness connector (1) from the panel door actuator and the floor/defrost door actuator as required.
4. Remove the mode door actuator(s) from the HVAC housing.

Rear

Blend Door Actuator - Removal|Page 6688 > < Blend Door Actuator - Removal|Page 6686