Durango 2WD V8-5.7L Hybrid (2009)
Control Assembly: Service and Repair
A/C and Heater Control - Installation
Front
INSTALLATION
1. Position the A/C-heater control (2) into the instrument panel center bezel (3).
2. Install the screws (1) that secure the A/C-heater control to the instrument panel center bezel. Tighten the screws to 2 Nm (17 in. lbs.).
3. Connect the wire harness connector(s) (2) to the A/C-heater control (3) and install the instrument panel center bezel (1) See: Body and
Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and Repair/Instrument Panel Bezel - Installation.
4. Reconnect the negative battery cable.
5. Initiate the Actuator Calibration function using a scan tool See: Testing and Inspection/Component Tests and General Diagnostics/HVAC System
Test.
Rear
INSTALLATION
