Durango 2WD V8-5.7L Hybrid (2009)
1. Position the front section of the A/C liquid line (2) into the engine compartment.
2. Remove the tape or plugs from the liquid line fitting and the condenser port.
3. Lubricate a new rubber O-ring seal with clean refrigerant oil and install it and a new gasket onto the liquid line fitting. Use only the specified
O-ring as it is made of a special material for the R-134a system. Use only refrigerant oil of the type recommended for the A/C compressor in the
vehicle.
4. Connect the A/C liquid line to the A/C condenser (3).
5. Install the nut (1) that secures the A/C liquid line to the A/C condenser. Tighten the nut to 22 Nm (16 ft. lbs.).
6. Remove the tape or plugs from the liquid line fitting and the receiver/drier (3).
7. Lubricate a new rubber O-ring seal with clean refrigerant oil and install it onto the liquid line fitting. Use only the specified O-ring as it is made of
a special material for the R-134a system. Use only refrigerant oil of the type recommended for the A/C compressor in the vehicle.
8. Connect the front section of the A/C liquid line (2) to the receiver/drier.
9. Install the bolt (1) that secures the front section of the A/C liquid line to the receiver/drier. Tighten the bolt to 13.5 Nm (120 in. lbs.).
