Durango 2WD V8-5.7L Hybrid (2009)
11. Remove the tape or plugs from the liquid line fitting and the receiver/drier (3).
12. Lubricate a new rubber O-ring seal with clean refrigerant oil and install it onto the liquid line fitting. Use only the specified O-ring as it is made of
a special material for the R-134a system. Use only refrigerant oil of the type recommended for the A/C compressor in the vehicle.
13. Connect the rear section of the A/C liquid line (2) to the receiver/drier.
14. Install the bolt (1) that secures the rear section of the A/C liquid line to the receiver/drier. Tighten the bolt to 11 Nm (97 in. lbs.).
15. On Hybrid Electric Vehicle (HEV) models, install the Traction Power Inverter Module (TPIM) (1) and mounting bracket (2) See: Hybrid Drive
Systems/Power Control System/Voltage Inverter/Service and Repair/Traction Power Inverter Module - Installation.
16. Install the TPIM coolant recovery bottle See: Engine, Cooling and Exhaust/Cooling System/Coolant Reservoir/Service and Repair/TPIM Coolant
Recovery Container - Installation.
