dodge Workshop Repair Guides

Dodge Workshop Service and Repair Manuals

Removal and Replacement|Page 7047 > < Removal and Replacement|Page 7045
Page 3
background image

3. Install the four nuts (1) that secure the HVAC housing (2) to the engine compartment side of the dash panel (3). Tighten the nuts to 7 Nm (62 in.

lbs.).

4. Tighten the two bolts that secure the HVAC housing to the passenger compartment side of the dash panel. Tighten the bolt(s) to 3 Nm (26 in. lbs.).
5. Connect the intermediate floor distribution duct to front floor distribution duct.
6. Install the instrument panel See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and Repair/Instrument Panel -

Installation.

7. Remove previously installed plugs or caps and connect the heater hoses to the heater core tubes.
8. Remove previously installed plugs or caps and install the A/C expansion valve and A/C liquid and suction lines See: Expansion Valve/Service and

Repair/A/C Expansion Valve - Installation.

9. Connect the 12 volt battery system.

WARNING: Always follow vehicle service procedures to properly connect batteries on an HEV model. Serious or fatal injury may result from

improper service procedures.

10. On Hybrid Electric Vehicles (HEV) models, connect the high voltage battery system using the service disconnect at the battery pack   See: Hybrid

Drive Systems/Battery System, Hybrid Drive/Service and Repair.

11. If the heater core is being replaced, flush the cooling system See: Engine, Cooling and Exhaust/Cooling System/Service and Repair.
12. Refill the engine cooling system See: Engine, Cooling and Exhaust/Cooling System/Service and Repair.
13. Evacuate and charge the refrigerant system See: Service and Repair/Refrigerant System Charge.

14. Initiate the Actuator Calibration function using a scan tool .  See: Testing and Inspection/Component Tests and General Diagnostics/HVAC

System Test

Rear HVAC Housing Removal

REMOVAL

WARNING: Refer to the applicable warnings and cautions for this system before performing the following operation See: Service

Precautions/Warning  and See: Specifications/Capacity Specifications/Refrigerant Oil Capacity . Failure to follow the warnings and
cautions may result in serious or fatal injury.

NOTE: The rear heater-A/C housing must be removed from the vehicle for service of the blower motor and disassembled for service of the

A/C evaporator, heater core, mode-air door and blend-air door.

Removal and Replacement|Page 7047 > < Removal and Replacement|Page 7045