Durango 2WD V8-5.7L Hybrid (2009)
NOTE: Blend door actuator coupler shown. Mode door coupler similar.
1. Install the two actuator couplers (1) into the rear heater-A/C housing. Be sure to install the couplers with the coupler arm (3) located between the
two stop tabs (4) on the rear heater-A/C housing.
NOTE: If a foam seal on an air door is deformed or damaged, the air door must be replaced.
2. Install the blend-air door (1) and the mode-air door (2) the rear heater-A/C housing (3). Align the notch in the air doors with the coupler and fully
engage the door to the coupler.
NOTE: If the insulator around the A/C evaporator or evaporator tubes is deformed or damaged, the insulator must be replaced.
3. Carefully install the rear A/C evaporator (1) into the outboard half of the rear heater-A/C housing (3).
