Durango 2WD V8-5.7L Hybrid (2009)
Battery Cooling Fan Relay: Service and Repair
High Voltage Battery Cooling Fan Micro Relay - Installation
INSTALLATION
WARNING: On vehicles equipped with the high voltage system, you must thoroughly read and follow all High Voltage Safety procedures. In
addition, before performing any diagnostic or service procedure near a high voltage component, you must perform the High
Voltage Power Down. Failure to follow these instructions may result in possible serious or fatal injury See: Battery System, Hybrid
Drive/Service Precautions
WARNING: Once the battery cover is removed from the battery, high voltage is still present in the system even with the service disconnect
removed. When performing any diagnostic or service procedures, use extreme care with tools and other test equipment around
unisolated terminals and wires. Failure to take proper precaution could result in serious or fatal injury.
1. Install the micro relay.
2. Install the eight bolts for the rear shield. Tighten to 10 Nm (7 ft. lbs.).
3. Install the high voltage battery cover See: Battery System, Hybrid Drive/Hybrid Battery Cover/Service and Repair/High Voltage Battery Cover -
Installation.
4. Perform the high voltage power up procedure . See: Battery System, Hybrid Drive/Service and Repair/Battery System - High Voltage Power Up
