Durango 2WD V8-5.7L Hybrid (2009)
Instrument Panel Bulb: Service and Repair
Illumination Lamp - Installation
EVIC Control
BULB - EVIC CONTROL
WARNING: To avoid serious or fatal injury on vehicles equipped with airbags, disable the Supplemental Restraint System (SRS) before
attempting any steering wheel, steering column, airbag, seat belt tensioner, impact sensor or instrument panel component
diagnosis or service. Disconnect and isolate the negative battery (ground) cable. Wait two minutes for the system capacitor to
discharge before performing further diagnosis or service. On vehicles equipped with the optional Hybrid Electric Vehicle (HEV)
system, a technician trained in proper HEV service safety procedures must also remove the high voltage service disconnect from
the high voltage battery pack. This is the only sure way to disable the SRS. Failure to take the proper precautions could result in
accidental airbag deployment. Failure to follow these instructions may result in possible serious or fatal injury.
CAUTION: Always use the correct bulb size and type for replacement. An incorrect bulb size or type may overheat and cause damage to the
lamp, the socket or the lamp wiring.
NOTE: There are provisions for up to four bulb/bulb holder units on the Electronic Vehicle Information Center (EVIC) circuit board. The
two outboard bulbs illuminate the EVIC push buttons, while the two center bulbs illuminate the universal transmitter push buttons.
1. Align the bulb holder and bulb (3) with the keyed opening in the circuit board of the Electronic Vehicle Information Center (EVIC) (2).
2. Insert the bulb holder and bulb straight into the circuit board until the bulb holder is firmly seated.
3. Using a small thin-bladed screwdriver, rotate the bulb holder clockwise about 30 degrees on the circuit board to lock it into place.
4. Reinstall the overhead console (1) onto the headliner. . See: Body and Frame/Interior Moulding / Trim/Console/Service and Repair/Overhead
Console - Installation
5. Reconnect the battery negative cable. On vehicles equipped with the optional Hybrid Electric Vehicle (HEV) system, a technician trained in
proper HEV service safety procedures must also reinstall the high voltage service disconnect into the high voltage battery pack.
Front A/C-Heat Control
BULB - FRONT A/C-HEAT CONTROL
WARNING: To avoid serious or fatal injury on vehicles equipped with airbags, disable the Supplemental Restraint System (SRS) before
attempting any steering wheel, steering column, airbag, seat belt tensioner, impact sensor or instrument panel component
diagnosis or service. Disconnect and isolate the negative battery (ground) cable. Wait two minutes for the system capacitor to
discharge before performing further diagnosis or service. On vehicles equipped with the optional Hybrid Electric Vehicle (HEV)
system, a technician trained in proper HEV service safety procedures must also remove the high voltage service disconnect from
the high voltage battery pack. This is the only sure way to disable the SRS. Failure to take the proper precautions could result in
accidental airbag deployment. Failure to follow these instructions may result in possible serious or fatal injury.
CAUTION: Always use the correct bulb size and type for replacement. An incorrect bulb size or type may overheat and cause damage to the
lamp, the socket or the lamp wiring.
