Durango 2WD V8-5.7L Hybrid (2009)
Parking Brake Warning Switch: Service and Repair
Parking Brake Switch - Removal
REMOVAL
WARNING: To avoid serious or fatal injury on vehicles equipped with airbags, disable the Supplemental Restraint System (SRS) before
attempting any steering wheel, steering column, airbag, seat belt tensioner, impact sensor or instrument panel component
diagnosis or service. Disconnect and isolate the negative battery (ground) cable. Wait two minutes for the system capacitor to
discharge before performing further diagnosis or service. On vehicles equipped with the optional Hybrid Electric Vehicle (HEV)
system, a technician trained in proper HEV service safety procedures must also remove the high voltage service disconnect from
the high voltage battery pack. This is the only sure way to disable the SRS. Failure to take the proper precautions could result in
accidental airbag deployment. Failure to follow these instructions may result in possible serious or fatal injury.
1. Disconnect and isolate the battery negative cable. On vehicles equipped with the optional Hybrid Electric Vehicle (HEV) system, a technician
trained in proper HEV service safety procedures must also remove the high voltage service disconnect from the high voltage battery pack.
2. Apply the parking brake.
3. Reach under the left end of the instrument panel to access and disconnect the body wire harness connector (2) from the terminal of the park brake
switch (4) located on the park brake lever mechanism (1) on the left cowl side inner panel.
4. Remove the screw (3) that secures the park brake switch to the park brake lever mechanism.
5. Remove the switch from the park brake lever mechanism.
