dodge Workshop Repair Guides

Dodge Workshop Service and Repair Manuals

Procedures|Page 1623 > < Procedures|Page 1621
Page 15
background image

NOTE: 5.7L gas only engine shown. 5.7L HEV engine similar.

1. On HEV models, disconnect the battery system using the service disconnect at the battery pack   See: Hybrid Drive Systems/Battery System,

Hybrid Drive/Service and Repair.

2. On gasoline only engine models, disconnect and isolate the negative battery cable.
3. Recover the refrigerant from the refrigerant system See: Heating and Air Conditioning/Service and Repair/Refrigerant System Recovery.
4. Remove the air cleaner housing and resonator See: Filters/Air Cleaner Housing/Service and Repair/Air Cleaner Body - Removal.
5. Remove the nut (1) that secures the front section of the A/C suction line (4) to the rear section of the A/C suction line (2).
6. Install plugs in, or tape over, the opened suction line fittings.

7. Raise and support the vehicle.
8. Remove the right front wheelhouse splash shield.
9. Remove the plastic retainer (1) that secures the rear section of the A/C suction line (2) to the liquid line tapping block (4).

10. Remove the nut (3) that secures the liquid line tapping block to the A/C expansion valve (5).
11. Disconnect the A/C suction and liquid lines from the A/C expansion valve and remove and discard the O-ring seals and gaskets.
12. Install plugs in, or tape over, the opened refrigerant line fittings and expansion valve ports.
13. Separate the A/C suction line from the liquid line tapping block.
14. On models equipped with the rear heating-A/C\ system, disconnect the underbody refrigerant line from the A/C suction line\ See: Heating and Air

Conditioning/Coupler HVAC/Service and Repair/Refrigerant Line Coupler - Removal  and See: A/C Suction Line - Removal.

15. Remove the rear section of the A/C suction line from the engine compartment.

Rear

REMOVAL

WARNING: On vehicles equipped with the high voltage system, you must thoroughly read and follow all High Voltage Safety procedures. In

addition, before performing any diagnostic or service procedure near a high voltage component, you must perform the High
Voltage Power Down. Failure to follow these instructions may result in possible serious or fatal injury 
See: Hybrid Drive
Systems/Battery System, Hybrid Drive/Service Precautions 

Procedures|Page 1623 > < Procedures|Page 1621