Durango 2WD V8-5.7L Hybrid (2009)
Spark Plug: Service and Repair
Spark Plug - Installation
5.7L
CAUTION: Never use a motorized wire wheel brush to clean spark plugs. Metallic deposits will remain on spark plug insulator and will cause
plug misfire.
CAUTION: Do not attempt to clean any of the spark plugs. Replace only.
1. Check and adjust the spark plug gap with a gap gauging tool (1) See: Specifications/Spark Plug Specifications.
CAUTION: Special care should be taken when installing spark plugs into the cylinder head spark plug wells. Be sure the plugs do not drop
into the plug wells as electrodes can be damaged.
2. Start the spark plug into the cylinder head by hand to avoid cross threading.
NOTE: Always tighten spark plugs to the specified torque. Certain engines use torque sensitive spark plugs. Over tightening can cause
distortion resulting in a change in the spark plug gap, or a cracked porcelain insulator.
NOTE: Spark plugs have a torque critical tapered design. Do not exceed 20 Nm (15 ft. lbs.).
3. Tighten the spark plugs to 18 Nm (13 ft. lbs.).
4. To aid in coil installation, apply silicone based grease such as Mopar(R) Dielectric Grease into spark plug end of ignition coil rubber boots. Also
apply this grease to the tops of spark plugs.
