Durango 2WD V8-5.7L Hybrid (2009)
Seat Heater Control Module: Service and Repair
Heated Seat Module - Removal
REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Open the liftgate and remove the upper D-pillar trim from the vehicle. See: Body and Frame/Interior Moulding / Trim/Trim Panel/Service and
Repair/Pillar Trim/D-Pillar Trim/Removal.
3. Remove the lower D-pillar trim from the vehicle. See: Body and Frame/Interior Moulding / Trim/Trim Panel/Service and Repair/Pillar
Trim/D-Pillar Trim/Removal.
4. Disconnect the wire harness connector from the back of the heated seat module (2).
5. Unsnap the heated seat module (2) from the D-pillar (1).
6. Remove the heated seat module (2) from the vehicle.