Durango 2WD V8-5.7L Hybrid (2009)
Third Row Outboard
THIRD ROW OUTBOARD
WARNING: To avoid serious or fatal injury during and following any seat belt or child restraint anchor service, carefully inspect all seat belts,
buckles, mounting hardware, retractors, tether straps, and anchors for proper installation, operation, or damage. Replace any belt
that is cut, frayed, or torn. Straighten any belt that is twisted. Tighten any loose fasteners. Replace any belt that has a damaged or
ineffective buckle or retractor. Replace any belt that has a bent or damaged latch plate or anchor plate. Replace any child
restraint anchor or the unit to which the anchor is integral that has been bent or damaged. Never attempt to repair a seat belt or
child restraint component. Always replace damaged or ineffective seat belt and child restraint components with the correct, new
and unused replacement parts listed in the Chrysler Mopar (R) Parts Catalog. Failure to follow these instructions may result in
possible serious or fatal injury.
1. Move the third row seat cushion to its storage position, but leave the third row seat back in its upright position for easiest access to the seat belt
lower anchor (2) on the quarter inner panel (3).
2. Remove the screw (1) that secures the lower anchor to the tapping plate on the quarter inner panel.
3. Remove the D-pillar trim panel (1) from the inside of the upper D-pillar. See: Body and Frame/Interior Moulding / Trim/Trim Panel/Service and
Repair/Pillar Trim/D-Pillar Trim/Removal.
4. Route the seat belt (2) and lower anchor through the access hole in the D-pillar trim panel.
5. Remove the screw (4) that secures the seat belt turning loop (3) to the inside of the upper D-pillar.
6. Remove the turning loop from the D-pillar.
7. Remove the quarter trim panel from the lower D-pillar. See: Body and Frame/Interior Moulding / Trim/Trim Panel/Service and Repair/Luggage
Compartment Trim/Quarter Trim Panel - Removal.
8. Remove the screw (6) that secures the retractor bracket (5) to the lower D-pillar.
9. Remove the third row seat belt and retractor from the D-pillar as a unit.
Second Row - Center
