dodge Workshop Repair Guides

Dodge Workshop Service and Repair Manuals

Seat Belt Retractor - Removal|Page 7470 > < Seat Belt Retractor - Removal|Page 7468
Page 4
background image

WARNING: To avoid serious or fatal injury during and following any seat belt or child restraint anchor service, carefully inspect all seat belts,

buckles, mounting hardware, retractors, tether straps, and anchors for proper installation, operation, or damage. Replace any belt
that is cut, frayed, or torn. Straighten any belt that is twisted. Tighten any loose fasteners. Replace any belt that has a damaged or
ineffective buckle or retractor. Replace any belt that has a bent or damaged latch plate or anchor plate. Replace any child
restraint anchor or the unit to which the anchor is integral that has been bent or damaged. Never attempt to repair a seat belt or
child restraint component. Always replace damaged or ineffective seat belt and child restraint components with the correct, new
and unused replacement parts listed in the Chrysler Mopar (R) Parts Catalog. Failure to follow these instructions may result in
possible serious or fatal injury.

1. Check to be certain that the molded plastic retractor cup (2) is properly installed in the retractor mounting hole (1) of the inner D-pillar, and that it

is in good condition.

2. Position the third row outboard seat belt and retractor (5) to the D-pillar as a unit.
3. Install and tighten the screw (6) that secures the retractor bracket to the lower D-pillar. Tighten the screw to 39 Nm (29 ft. lbs.).
4. Position the seat belt turning loop (3) to the inside of the upper D-pillar.
5. Install and tighten the screw (4) that secures the turning loop to the D-pillar. Tighten the screw to 39 Nm (29 ft. lbs.).
6. Reinstall the quarter trim panel to the lower D-pillar. See: Body and Frame/Interior Moulding / Trim/Trim Panel/Service and Repair/Luggage

Compartment Trim/Quarter Trim Panel - Installation.

7. Route the seat belt (2) and lower anchor through the access hole in the D-pillar trim panel (1).
8. Reinstall the D-pillar trim panel to the inside of the upper D-pillar. See: Body and Frame/Interior Moulding / Trim/Trim Panel/Service and

Repair/Pillar Trim/D-Pillar Trim/Installation.

Seat Belt Retractor - Removal|Page 7470 > < Seat Belt Retractor - Removal|Page 7468