Durango 2WD V8-5.7L Hybrid (2009)
Second Row - Outboard
SECOND ROW - OUTBOARD
WARNING: To avoid serious or fatal injury during and following any seat belt or child restraint anchor service, carefully inspect all seat belts,
buckles, mounting hardware, retractors, tether straps, and anchors for proper installation, operation, or damage. Replace any belt
that is cut, frayed, or torn. Straighten any belt that is twisted. Tighten any loose fasteners. Replace any belt that has a damaged or
ineffective buckle or retractor. Replace any belt that has a bent or damaged latch plate or anchor plate. Replace any child
restraint anchor or the unit to which the anchor is integral that has been bent or damaged. Never attempt to repair a seat belt or
child restraint component. Always replace damaged or ineffective seat belt and child restraint components with the correct, new
and unused replacement parts listed in the Chrysler Mopar (R) Parts Catalog. Failure to follow these instructions may result in
possible serious or fatal injury.
1. Check to be certain that the molded plastic retractor cup is properly installed in the retractor mounting hole of the inner C-pillar, and that it is in
good condition.
2. Position the second row outboard seat belt and retractor (1) to the C-pillar as a unit.
3. Engage the tab on the retractor bracket into the engagement hole in the C-pillar.
4. Install and tighten the screw (5) that secures the retractor to the lower C-pillar. Tighten the screw to 39 Nm (29 ft. lbs.).
5. Route the seat belt lower anchor and turning loop through the access hole in the quarter trim panel.
6. Reinstall the quarter trim panel onto the lower C-pillar. See: Body and Frame/Interior Moulding / Trim/Trim Panel/Service and Repair/Luggage
Compartment Trim/Quarter Trim Panel - Installation.
7. Position the lower seat belt anchor (3) to the rear floor panel.
8. Install and tighten the screw (4) that secures the lower seat belt anchor to the floor. Tighten the screw to 39 Nm (29 ft. lbs.).
9. Reinstall the upper trim (2) onto the inside of the C-pillar (5). See: Body and Frame/Interior Moulding / Trim/Trim Panel/Service and Repair/Pillar
Trim/C-Pillar Trim Panel-Installation.
10. Position the seat belt turning loop (4) to the height adjuster (1) on the upper C-pillar.
11. Install and tighten the screw (3) that secures the turning loop to the height adjuster. Tighten the screw to 39 Nm (29 ft. lbs.).
