Durango 2WD V8-5.7L Hybrid (2009)
6. Place the 12 Volt battery charger to a medium setting and turn ON the battery charger to allow the high voltage battery to charge.
CAUTION: Using a setting higher then a medium rate of charge could damage the 12 Volt battery.
7. If the 12 Volt battery charger has been properly connected and the system determines that the conditions are correct for charging, the navigation
radio displays a message "CHARGING in Progress".
NOTE: To minimize the charging time, it is recommended to leave the key in the OFF position while in the "CHARGING in Progress" mode,
however the key may be turned to the ON/RUN position to use an accessory.
Allow the system to charge until the navigation radio displays the "Attempt to start vehicle" message.
8. Attempt to start the vehicle, if the vehicle starts, leave it running and turn off the 12 Volt battery charger.
9. Remove the 12 Volt battery charger negative clamp.
CAUTION: Be careful of the moving belt and fan blades.
10. Remove the 12 Volt battery charger positive clamp.
WARNING: Any procedure other than above could result in:
-
personal injury caused by electrolyte squirting out the battery vent.
-
personal injury or property damage due to battery explosion.
-
damage to charging system or immobilized vehicle.
Failure to follow these instructions may result in possible serious or fatal injury.
Charging Aborted
