Durango 2WD V8-5.7L Hybrid (2009)
If the "Jump Assist" procedure is interrupted, the navigation radio displays "Charge Aborted".
"Jump Assist" can be aborted by the following items:
-
the key is turned to the START position while the system is being charged.
-
incorrect installation of the 12 Volt battery charger.
-
poor cable clamp contact.
-
the Hybrid Control Module determines conditions are not suitable for charging.
If the "Charge Aborted" message is displayed check the battery charger clamps, make sure there is a good connection. Check to see that the 12 Volt
battery charger is turned on. Turn off the ignition, wait 10 to 15 seconds and turn the key to the START position. If the "Charge Aborted" message is still
active have the vehicle towed to the nearest authorized dealer for service.
Jump-Starting - 12 Volt Battery
Jumper Cable Clamp Connections
WARNING:
-
battery fluid is a corrosive acid solution; do not allow battery fluid to contact eyes, skin or clothing. Don't lean over battery
when attaching clamps or allow the clamps to touch each other. If acid splashes in eyes or on skin, flush the contaminated area
immediately with large quantities of water.
-
a battery generates hydrogen gas which is flammable and explosive. Keep flame or spark away from the vent holes. Do not use
