Durango 2WD V8-5.7L Hybrid (2009)
Torsion Bar: Service and Repair
Front Suspension Torsion Bar Crossmember Bushing - Installation
TORSION BAR CROSS MEMBER BUSHING
NOTE: Extreme pressure lubrication must be used on the threaded portions of the tool. This will increase the longevity of the tool and insure
proper operation during the removal and installation process.
1. Install the new bushing (3) into the cross member using special tools C4212-F (Press)(1), 9335-3(Driver)(2), 9335-4 (Spacer)(4) and 9335-1
(Depth setting cup)(5) making sure to properly orient the bushing.
2. Remove the cross member from the vise.
3. Install the torsion bar cross member.
4. Reset the vehicle ride height See: Alignment/Service and Repair.
5. Perform a wheel alignment See: Alignment/Service and Repair.
