Durango 2WD V8-5.7L Hybrid (2009)
NOTE: Orientate the alignment tab inside the passage sleeve with the slot in the electrical connector of the control solenoid valve assembly.
Push the sleeve straight into the case bore and connector. Do NOT rotate the sleeve at any time. Ensure the sleeve is fully seated into
the case. When the sleeve is properly installed, the distance from the case surface to the end of the sleeve should be 14-16 mm.
7. Lubricate the seals on the passage sleeve with DEXRON(R) VI. Install the passage sleeve (2). Push down on the passage locking tab (1) to secure.
NOTE: Using a suitable solvent, clean the oil pan and magnet.
8. Install the auxiliary oil filter assembly (3).
9. Install the primary oil filter assembly (2).
10. Install the oil pan gasket and the oil pan (1) onto the transmission case. Install the oil pan bolts. Tighten the oil pan bolts to 27 Nm (19 ft.lbs.).
11. Install the auxiliary oil pump (2) with a NEW gasket.
12. Install the auxiliary oil pump bolts (1). Tighten the bolts to 11 Nm (97 in.lbs.).
13. Check and fill the transmission as necessary with DEXRON(R) VI transmission fluid.
