Durango 2WD V8-5.7L Hybrid (2009)
6. Apply primer (1) around the perimeter of the glass to a width of 15 mm (0.5 in.) (3).
NOTE: Make sure the primer does not touch the locating pins and tabs (2, 4).
7. Allow primer to air dry for at least 10 minutes.
8. Using a flash light, verify that glass primer is without damage.
Glass Preparation - Installing A New Quarter Glass
NOTE: Typical primer installation shown.
1. Clean and dry area of glass (2) to be re-glued with a suitable glass preparation solvent and rag.
2. Apply primer to gluing surface at quarter glass seal.
