Durango 2WD V8-5.7L VIN 2 (2007)
Memory Positioning Module: Customer Interest
Memory Systems - Wrong Seat Position After Remote Start
NUMBER: 08-036-06
GROUP: Electrical
DATE: August 24, 2006
THE StarSCAN(R) FLASH FILES FOR THIS BULLETIN MUST BE RETRIEVED FROM THE INTERNET ON OR AFTER OCTOBER 6, 2006.
StarSCAN(R) UPDATE CD 6.05 WAS THE LAST CD TO CONTAIN FLASH FILES.
SUBJECT:
FLASH: Wrong Driver Seat Position May Occur After A Remote Start Event
OVERVIEW:
This bulletin involves selectively erasing and reprogramming the Memory Seat Module (MSMD) with new software.
MODELS:
2006 - 2007
(HB)
Durango
2007
(HG)
Aspen
2007
(WH)
Grand Cherokee (International Markets)
2007
(WK)
Grand Cherokee
2007
(XH)
Commander (International Markets)
2007
(XK)
Commander
NOTE:
This bulletin applies to vehicles equipped with Remote Start (sales code XBM).
SYMPTOM/CONDITION:
The MSMD interprets the remote start event as an OFF-to-RUN ignition key transition instead of a remote start, resulting in either the movement of the
driver seat to the memory driving position prior to driver entry or, no movement from the Easy Exit position following the actual OFF-to-RUN ignition
key transition.
DIAGNOSIS:
Using a Scan Tool (StarSCAN(R)) with the appropriate Diagnostic Procedures available in TechCONNECT, verify all systems are functioning as
designed. If DTCs are present record them on the repair order and repair as necessary before proceeding further with this bulletin.
If the vehicle operator describes or experiences the Symptom/Condition, perform the Repair Procedure.
SPECIAL TOOLS / EQUIPMENT REQUIRED:
