Durango 2WD V8-5.7L VIN 2 (2007)
Seat Heater Control Module: Service and Repair
Switch/Module - Second Row Heated Seat
Removal
REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Using an appropriate flat bladed tool, remove the heated seat switch/modules (2) from the rear center floor console (3) by gently prying up from
the edge of the switch/module bezel (1). Take care not to scratch or damage the console or bezel in any way.
3. Disconnect the switch/module electrical connectors (2) and (4).
4. Using an appropriate flat bladed tool, remove the heated seat switch/module (3) from the bezel (1).
Installation
INSTALLATION
