Durango 2WD V8-5.7L VIN 2 (2007)
Seat Heater Control Module: Service and Repair
Module-Heated Seat
Removal
REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Open the liftgate and remove the upper D-pillar trim from the vehicle.
3. Remove the lower D-pillar trim from the vehicle.
4. Disconnect the wire harness connector from the back of the heated seat module (2).
5. Unsnap the heated seat module (2) from the D-pillar (1).
6. Remove the heated seat module (2) from the vehicle.
Installation
INSTALLATION
1. Install the heated seat module on the D-pillar (1).
