Durango 2WD V8-5.7L VIN 2 (2007)
Condenser HVAC: Service and Repair
Removal
REMOVAL
WARNING: Refer to the applicable warnings and cautions for this system before performing the following operation. Failure to follow the
warnings and cautions could result in possible personal injury or death.
1. Disconnect and isolate the negative battery cable.
2. Recover the refrigerant from the refrigerant system.
3. Remove the push-pin retainers (1) and the upper condenser/radiator seal (2).
4. Disconnect the wire harness connectors from the condenser cooling fan motor (9) and the A/C pressure transducer (10).
5. Remove the two wire harness retainers (2) from the condenser fan shroud (4) and position the wire harness out of the way.
6. Remove the nuts (1 and 8) that secure the A/C discharge line (5) and A/C liquid line (7) to the A/C condenser (6).
7. Disconnect the A/C discharge and liquid lines from the A/C condenser and remove and discard the O-ring seals and gaskets.
8. Remove the A/C discharge line from the retainer (3) located on the condenser fan shroud (4).
9. Install plugs in, or tape over the opened discharge and liquid line fitting and condenser ports.
