Durango 2WD V8-5.7L VIN 2 (2007)
11. Connect the underbody heater hoses to the front heater hoses and install the heater hose clamps.
12. Remove the tape or plugs from the refrigerant line couplers (6) and the underbody refrigerant lines.
13. Lubricate a new rubber O-ring seal with clean refrigerant oil and install them onto the refrigerant line couplers. Use only the specified O-ring as it
is made of a special material for the R-134a system. Use only refrigerant oil of the type recommended for the A/C compressor in the vehicle.
14. Connect the underbody liquid and suction lines to the liquid line extension tube (8) and the suction line extension tube (5).
15. Install the secondary retaining clips (2 and 7) onto the refrigerant line couplers.
16. Install passenger side tires.
17. Install the right front wheelhouse splash shield.
18. Lower the vehicle.
19. Reconnect the negative battery cable.
20. Fill the engine cooling system.
21. Evacuate the refrigerant system.
22. Adjust the refrigerant oil level.
23. Charge the refrigerant system.
