Durango 2WD V8-5.7L VIN 2 (2007)
1. Align the bulb holder and bulb (3) with the keyed opening in the circuit board of the front A/C-heater control (2).
2. Insert the bulb holder and bulb straight into the circuit board until the bulb holder is firmly seated.
3. Using a small thin-bladed screwdriver, rotate the bulb holder clockwise about 30 degrees on the circuit board to lock it into place.
4. Reinstall the center bezel (1) onto the instrument panel.
5. Reconnect the battery negative cable.
Bulb - Rear A/C-Heat Control
BULB - REAR A/C-HEAT CONTROL
CAUTION: Always use the correct bulb size and type for replacement. An incorrect bulb size or type may overheat and cause damage to the
lamp, the socket or the lamp wiring.
1. Align the bulb holder and bulb (2) with the keyed opening in the circuit board of the rear A/C-heater control (1).
2. Insert the bulb holder and bulb straight into the circuit board until the bulb holder is firmly seated.
3. Using a small thin-bladed screwdriver, rotate the bulb holder clockwise about 30 degrees on the circuit board to lock it into place.
4. Reinstall the rear A/C-heater control onto the center floor console.
5. Reconnect the battery negative cable.
