Durango 2WD V8-5.7L VIN 2 (2007)
NOTE: The overhead console on vehicles with the Light Emitting Diode (LED) lighting package contains three LED units, each with its own dedicated
printed circuit board. The two outboard articulating eyeball-type LED reading lamp pod units with their integral lens-actuated switches and printed
circuit boards are available for separate service replacement. However, if the fixed center LED unit or printed circuit board is damaged or ineffective, the
entire overhead console housing unit must be replaced.
1. Disconnect and isolate the battery negative cable.
2. Remove the overhead console unit (4) from the headliner.
3. From the top of the overhead console housing, disconnect the pod pigtail wire connector (2) from the fixed dome lamp printed circuit board in the
center of the console housing.
4. Pry gently and evenly on one of the pod mounting stanchions (1) far enough to disengage the pivot pin on one side of the pod (3).
5. Pry gently and evenly on the mounting stanchion on the opposite side of the pod far enough to disengage the opposite pivot pin.
6. Lift the pod out of its receptacle within the overhead console housing.
