Durango 2WD V8-5.7L VIN 2 (2007)
Combination Switch: Testing and Inspection
MULTI-FUNCTION SWITCH
WARNING: To avoid serious or fatal injury on vehicles equipped with airbags, disable the supplemental restraint system before attempting
any steering wheel, steering column, airbag, seat belt tensioner, impact sensor, or instrument panel component diagnosis or service. Disconnect
and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to discharge before performing further
diagnosis or service. This is the only sure way to disable the supplemental restraint system. Failure to take the proper precautions could result
in accidental airbag deployment.
1. Remove the multi-function switch from the switch mounting housing on the steering column.
2. Disconnect the wire harness connector from the back of the multi-function switch.
3. Using an ohmmeter, test the resistance between the terminals of the switch as shown in the Multi-Function Switch Tests table.
