dodge Workshop Repair Guides

Dodge Durango V8 57L Workshop Service & Repair Manuals

Wheels and Tires|Tires > < Tire Pressure Sensor|Removal|Page 2307
Page 3
background image

Rotating Tool Tire Changers - Position the wheel on the changer so that the sensor valve stem (1) is located approximately 180° clockwise from
the installation end of the mounting/dismounting tool (2) once the tool is mounted for tire installation. Make sure the sensor is clear of the lower
bead breaker area (3) to avoid damaging the sensor when the breaker rises. Rotate the tool (2) in a counterclockwise direction to mount the tire.
Use this procedure on both the upper and lower tire beads.

6.   Adjust air pressure to that listed on Tire Inflation Pressure Label (Placard) provided with vehicle (usually applied to driver's side B-pillar). Make

sure original style valve stem cap is securely installed to keep moisture out of sensor.

7.   Install tire and wheel assembly on vehicle.
8.   Lower vehicle.
9.   If the vehicle has been stationary for more then 20 minutes, drive the vehicle for a minimum of 10 minutes while maintaining a continuous speed

above 15 mph (24 km/h). During this time, the system will learn the new sensor ID.

NOTE: If a sensor cannot be trained, refer to appropriate diagnostic information.

SPARE TIRE SENSOR REPLACEMENT

NOTE: When the spare tire sensor is replaced on vehicles equipped with a Tire Pressure Monitoring System (TPMS) and a full-sized
matching spare tire and wheel assembly, a diagnostic scan tool MUST be used to run a routine that will program the new pressure sensor
ID into the Wireless Control Module (WCM), commonly referred to as the Sentry Key Remote Entry Module (SKREEM). Please copy
the ID number off of the new pressure sensor before installing it into the spare tire. Then follow the programming steps outlined in the
diagnostic scan tool for: "Learn Spare Tire Sensor ID" under Miscellaneous Functions for the (WCM) Wireless Control Module menu
item as appropriate. If a TPM-RKE Analyzer special tool is available, put the new spare tire pressure sensor into "Park" mode. If a
TPM-RKE Analyzer special tool is not available, rotate the spare tire with one of the road tires.

Wheels and Tires|Tires > < Tire Pressure Sensor|Removal|Page 2307