Durango 2WD V8-5.7L VIN 2 (2007)
8.
Reconnect the CH9404 StarSCAN vehicle cable to the vehicle.
9.
Retrieve the PCM part number. With the StarSCAN on the "Home" screen, follow the procedure below:
a.
Select "ECU View".
b.
Touch the screen to highlight "PCM" in the list of modules.
c.
Select "More Options".
d.
Select "ECU Flash".
e.
Verify the "Part Number" (displayed at the end of the "Resident flash file for" statement) has been updated to the new part number. If it has
updated, then the flash has been completed successfully.
NOTE:
Due to the PCM programming procedure, a Diagnostic Trouble Code (DTC) may be set in other modules (ABS, TCM, BCM, MIC, WCM, etc.)
within the vehicle, if so equipped. Some DTC's may cause the MIL to illuminate. From the "Home" screen select "System View". Then select "All
DTC's". Press "Clear All Stored DTC's" if there are any DTC's shown on the list.
10.
Disconnect the StarSCAN and battery charger from the vehicle.
B.
Install the Authorized Modifications Label:
1.
Type or print (with a ballpoint pen) the recall number, dealer code and date on the Authorized Modifications Label (Figure 1).
2.
Attach the label near the VECI label and then close the hood.
